The Fitting Studio That Actually Looks at Your Miss.
Most fitting carts stop at loft and shaft. We go one step further and match the bulge-and-roll camber ground into your driver and fairway wood face to the way you actually strike the ball — so an off-center hit still holds its line instead of leaking sideways into the trees. Full bag work, too: irons, wedges, and putters, all built on our own bench a few blocks off Campbell Avenue.
Every Club Gets Its Own Bench Time
We treat the driver and fairway woods as a camber-matching problem first, then work down through the rest of the bag with the same demand for numbers over guesswork.
Camber Matching: The Fitting Step Most Shops Skip
Every driver and fairway wood face is curved in two directions — horizontally (bulge) and vertically (roll). That curvature exists to fight gear effect: the sidespin an off-center strike puts on the ball as the clubhead twists at impact. Stock curvature is set for an average miss pattern. Yours probably isn't average.
We map where your strikes actually land across the face over a real session, not a single swing.
We compare bulge and roll radii across current head models to find the curvature that best offsets your specific miss.
You leave with a dispersion report showing your toe/heel misses before and after the camber-matched build.
Four Stops From First Swing to New Clubs
Strike Mapping
Foot spray and launch data log exactly where your current clubs meet the ball across a full bucket.
Camber Comparison
We hit demo heads with different bulge/roll radii side by side against your actual miss pattern.
Spec Build-Out
Head, shaft, length, and lie/loft get locked in together, camber included, not bolted on after.
Bench & Verify
Clubs are built in-house and checked on our frequency rig before you ever take them to the course.
What a Camber-Matched Bag Actually Feels Like
I'd been fighting a toe miss for a decade and every shop told me it was swing path. Camber Line matched a wider bulge radius to my strike pattern and the ball just stopped leaking right.
Full bag rebuild with a real gapping report. My irons and wedges finally talk to each other, yardage to yardage, instead of overlapping in the middle of the set.
They showed me the dispersion chart before and after — heel strikes that used to hook 18 yards left now finish inside 7. Numbers, not a sales pitch.
Curious What Your Own Curvature Chart Looks Like?
Sessions run 60–90 minutes and include a written dispersion report. Fitting fees are credited toward any club built on our bench.